Excellent Compact B2 Coils Not Dispensing

If your EC is not dispensing coffee, the coil gasket may be misaligned. Here is the recent service bulletin.


If you suspect one of both gaskets are misaligned, please follow these instructions.

-Verify coil is good


-If coil is good. Remove the fridge box

Remove the back panel and remove the air funnel.  Disconnect the wires.Then start from the top.








Then align the gaskets.





Comments

Post a Comment

Popular posts from this blog

NG E12 Error

Image
Multiple E12 Errors on NG 110/300 Black E12 If you have a machine that has multiple boiler level (E12) errors, please follow these steps: 1. Check level sensor continuity 2. Check wire harness continuity If continuity exists and both are OK , revert the software . You will need to go to BOX and download the previous software onto your tablet, then connect your Blue Box to the machine to revert the software following the instructions below. If you have an trouble, Smuckers has provided the tech support number in the instructions 800-477-7490
Read more

Excellent Compact Water Softener Filter

Image
Excellent Compact Water Softener Filter As stated in a previous blog regarding erroneous E21 errors, our solution has been to clean the level pin AND add a special water softener filter #5633001 . These filters should have already been sent to technicians that have an Excellent Compact in their area. Please check your inventory. If you do not have a #5633001 filter, please get with the office and request one. We need to have these on hand whenever we have a service call for an EC just in case. Adding this filter has been helping with this issue and we will continue with this coarse of action to remedy these errors. Please contact me by phone, text or email with your name by 4:00pm on Thursday 08/22/19 and you will receive a gift card for a free lunch courtesy of Mike and Rita as a thank you for YOUR due diligence in reading the service information that we put out. Angela Aschenbrenner aaschenbrenner@prestigetech.us 636-249-8308
Read more

NG LOW TEMP FEATURE INSTALLATION AND TIPS

Image
PLEASE READ AND SAVE FOR QUICK REFERENCE Remember, the more you know, the easier your job becomes! NG LOW TEMP FEATURE INSTALLATION AND TIPS BEFORE HEADING TO SITE: 1. You MUST have the latest version of Smuckers WBSD Tool on your tablet (V1.12.00 or greater) 2. You MUST have the latest version of NG 110 firmware update on your tablet (V1.02.00or greater) 3. You MUST have the latest version of NG 300 firmware update on your tablet (V1.02.00 or greater) ONCE ON SITE: 1. Confirm water connection is a COLD WATER connection ONLY 2. Verify with customer what temperature they are wanting the COFFEE, not the tank temp 3. Verify with customer there is a MANDATORY clean/flush cycle (approx. 10 mins) every week. It is their choice on which day, but it WILL BLOCK OUT THE COFFEE if not performed. Now, install the machine and filter as normal, or skip to next section if you are just adding the feature only to a machine that is already installed. INSTALLATION OF THE LO
Read more